Great for students,
repairers, occasional polishers, model makers and
lots of other trades and home use. In fact anyone
who wants a polishing system but does not want a
sophisticated extracted unit.
All welded Black Polypropylene construction - virtually
unbreakable.
“BUFFA”
will not split or shatter if hit by articles during
polishing
Very quiet, mounted on rubber non-slip
feet.
Can be adapted to connect to small
domestic and industrial “HENRY” type
suction units or even vacuum cleaners.
BUFFA
unit includes Polishing motor, enclosure and plug.
To use your “BUFFA”
polishing unit, place on a firm work top.
Turn the red switch to “o” and plug
into a normal three pin 240 volts socket and switch
on. Put your polishing mop onto either spindle
and rotate to tighten into place. It is recommended
to put a mop on each spindle for safety reasons.
Turn the red switch to “I”, ensuring
your hands are clear, the mop will now turn. Do
not exceed mop sizes of 150mm Ø, 100mm
Ø is recommended. If the motor slows, reduce
the work pressure on the mop. If the motor becomes
hot, stop polishing and allow the motor to run
for 5 minutes
without polishing to cool down. Do not wear loose
clothes. Jewellery or long hair can become tangled
around the polishing mop. Do not polish when tired
or under the influence of alcohol or drugs.
“BUFFA”
Extraction adaptor kit number 6753D allows the
unit to be extracted and comprises of two circular
outlets on ound panels. To fit: Cut two 50mm holes
in the rear of the unit behind the polishing mops.
Place suction connector over the holes and screw
panels with the self tapping screws. Connect your
extractor / vacuum unit to either outlet. Note:
most domestic vacuum cleaners are not designed
to run non - stop, use for 15 minutes maximum,
unless continuously rated.Refer to vacuum handbook
for further information.
|
Acid Tanks
